Dell EMC PowerEdge R740xd2 - Removing the Right Control Panel

Figure 137. Installing the left control panel
3 Connect the control panel cable to the system board connector.
Next steps
1 Install the cable chain assembly.
2 Close the drive bays.
3 Place the system into the rack. For more information, see the Rail Installation Guide available at www.dell.com/poweredgemanuals.
4 Install the power supply units.
5 Open the drive bays, install all drives, and then close the drive bays.
6 If removed, install the front bezel.
7 Follow the procedure listed in After working inside your system.
Removing the right control panel
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Power o the system and all attached peripherals.
3 Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.
4 Open the drive bays, remove all drives, and then close the drive bays.
5 Remove the power supply units.
6 Remove the system from the rack and place it on an ESD work bench. For more information, see the Rail Installation Guide available at
www.dell.com/poweredgemanuals.
7 If installed, remove front bezel.
8 Remove the system cover.
168
Installing and removing system components