8 Remove the system cover.
9 Remove the air shroud.
10 Remove the IDSDM or vFlash module.
NOTE: To use an MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE: If reinstalling, ensure that you install the MicroSD cards into the same slots based on the labels you had marked on the
cards during removal.
Steps
1 Locate the MicroSD card connector on the IDSDM/vFlash module. Orient the MicroSD card appropriately and insert the contact-pin
end of the card into the slot.
NOTE: The slot is designed to ensure correct insertion of the card.
2 Press the card into the card slot to lock it into place.
Figure 111. Installing the MicroSD card
Next steps
1 Install the IDSDM or vFlash module.
2 Install the air shroud.
3 Install the system cover.
4 Place the system into the rack. For more information, see the Rail Installation Guide available at www.dell.com/poweredgemanuals.
5 Open the drive bays, install all drives, and then close the drive bays.
6 Install the power supply units.
7 Follow the procedure listed in After working inside your system.
Installing and removing system components
137
To Next Page
Loading...
