g Memory modules for processor 1.
h PIB.
11 Disconnect all cables connected to the cable chain assembly from the backplanes and the system board.
Steps
1 Place the cable chain assembly in the system and route the left control panel cable through the cable chain base bracket.
2 Using a Phillips #1 screwdriver, replace the screws for the cable chain rail after aligning it to the chassis and align the cable chain
assembly to the bottom screw holes.
Figure 132. Placing the cable chain assembly in the system
3 Slide the left side of the system, partially o the table, until the bottom screws holes for the cable chain base bracket are visible and
replace the screws.
4 Align the cable chain side cover to the guiding pins on the system and tighten the captive screw.
162
Installing and removing system components
To Next Page
Loading...
