11 Remove the internal PERC riser.
Steps
1 Align the PERC card to the guiding pins on the internal PERC riser and push the card in.
2 Route the battery cable around the riser and connect to the PERC card.
Figure 32. Installing the PERC card into internal PERC riser
Next steps
1 Install the internal PERC riser
2 If removed, install the rear drive cage.
3 Install the air shroud.
4 Install the system cover.
5 Place the system into the rack. For more information, see the Rail Installation Guide available at www.dell.com/poweredgemanuals.
6 Open the drive bays, install all drives, and then close the drive bays.
7 Install the power supply units.
8 Follow the procedure listed in After working inside your system.
60
Installing and removing system components
To Next Page
Loading...
