Dell D30M - Page 111

Figure 82. Installing the system board
Figure 83. Installing the system board
Steps
1. Slide the front I/O ports on the system board into the front I/O slots on the chassis and align the screw holes on the system
board with the screw holes on the chassis.
2. Replace the nine (#6-32) and two (M2) screws that secure the system board to the chassis.
3. Route the cables through the routing guides on the chassis and connect the power and hard drive cables to their respective
connectors on the system board.
4. Align the front I/O bracket with the slots on the chassis.
Removing and installing Field Replaceable Units (FRUs)
111