5. Replace the (#6-32) screw that secures the front I/O bracket to the chassis.
Next steps
1. Install the internal speaker.
2. Install the intrusion switch.
3. Install the front chassis fan and rear chassis fan.
4. Install the processor.
5. Install the 125 W heat-sink assembly or 65 W heat-sink assembly.
6. Install the powered GPU.
NOTE: This step is required only if the system is configured with a powered GPU.
7. Install the graphics card.
8. Install the memory module.
9. Install the coin-cell battery.
10. Install the WLAN.
11. Install the M.2 2230 SSD/M.2 2280 SSD.
12. Install the 3.5-inch HDD.
13. Install the air shroud.
NOTE: For systems with 500W/1000W PSU only.
14. Install the front bezel.
15. Install the side cover.
16. Follow the procedure in after working inside your computer.
NOTE:
Your computer’s Service Tag is stored on the system board. You must enter the Service Tag in the BIOS setup
program after you replace the system board.
NOTE: Replacing the system board removes any changes that you have made to the BIOS using the BIOS setup
program. You must make the appropriate changes again after you replace the system board.
112 Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
