Dell OptiPlex Gn - Chapter 6 Removing and Replacing Parts on the Mini Tower Chassis; Recommended Tools

Removing and Replacing Parts on the Mini Tower Chassis 6-1
Chapter 6
Removin
g
and Replacin
g
Parts
on the Mini Tower Chassis
T
his chapter provides procedures for removing the components, assemblies,
and subassemblies in the Dell OptiPlex Gn and Gn+ mini tower computer. If
you are servicing a Dell OptiPlex Gn and Gn+ low-profile or midsize computer,
use Chapter 4, “Removing and Replacing Parts on the Low-Profile Chassis,” or
Chapter 5, “Removing and Replacing Parts on the Midsize Chassis.”
Unless otherwise noted, each procedure assumes the following:
•
You have performed the steps in “Precautionary Measures” found later in
this chapter.
•
You have removed the computer cover.
•
You can replace or reinstall a part by performing the removal procedure in
reverse order unless additional information is provided.
R
ecommended Tools
Most of the procedures in this chapter require the use of one or more of the fol-
lowing tools:
•
Small flat-blade screwdriver
•
Wide flat-blade screwdriver
•
#1 and #2 Phillips-head screwdrivers
•
1/4
-inch nutdriver
•
Tweezers or long-nose pliers
Also, use a wrist grounding strap as explained in the next section, “Precaution-
ary Measures.”