Removing and Replacing Parts on the Low-Profile Chassis 4-3
F
loor Stand
Figure 4-1. Optional Floor Stand Removal
To remove the floor stand, if one is installed, follow these steps:
1. Place the right side of the computer on a flat work surface.
2. Unscrew the captive screw.
Use your fingers or a wide flat-blade screwdriver to unscrew the floor stand
screw.
3. Pull the floor stand away from the computer.
Disengage the locator pin that positions and helps secure the floor stand to
the computer.
securing
button
locator hole
captive screw
locator pin (on under-
side of floor stand)
To Next Page
Loading...
