Dell OptiPlex Gn - Eject, Power, and Reset Buttons; Figure 4-4. Eject, Power, and Reset Button Removal

Removing and Replacing Parts on the Low-Profile Chassis 4-5
E
ject, Power, and Reset Buttons
Figure 4-4. Eject, Power, and Reset Button Removal
To remove the e
j
ect,
p
ower, and reset buttons, follow these ste
p
s:
1. Lay the computer cover upside down on a flat work surface, with the
back of the cover facing you.
2. To remove the 3.5-inch diskette-drive eject button, pull gently on the
plastic part of the button until it comes free.
3. To remove the power button or the reset button, use a small screw-
driver and push in the two or three plastic clips that hold the button to
the computer cover.
When these cli
p
s are released, the button comes free from the front
p
anel of
the cover.
power button
reset button
eject button
computer cover
(upside down)