Dell OptiPlex Gn - Control Panel; Figure 5-7. Control Panel Removal

5-8
Dell OptiPlex Gn and Gn+ Systems Service Manual
C
ontrol Panel
Figure 5-7. Control Panel Removal
To remove the control panel, follow these steps:
1. Remove the hard-disk drive bracket.
2. Disconnect the control panel cable from the PANEL connector on the
system board (see Figure 5-15).
3. Remove the mounting screw securing the control panel to the chassis.
4. Slide the control panel out of the hooks securing it to the chassis.
Note the routing of the control-panel cable as you remove it from the
chassis.
control panel
control panel
cable
screw
chassis hooks (2)