Dell OptiPlex Gn - Drives; Figure 4-8. Drive Hardware

Removing and Replacing Parts on the Low-Profile Chassis 4-9
D
rives
Figure 4-8 shows an example of drive hardware that can be installed in the com-
puter. Refer to this figure when you perform any of the procedures in the
following subsections.
Figure 4-8. Drive Hardware
diskette/tape drive
interface cable
DC power cable
hard-disk drive
3.5-inch diskette drive
EIDE cable
5.25-inch drive
bay and bracket
DSKT connector
system
power supply
secondary EIDE
connector (IDE2)
primary EIDE
connector (IDE1)