5-18
Dell OptiPlex Gn and Gn+ Systems Service Manual
Riser Board
Figure 5-18. Riser Board Removal
To remove the riser board, follow these ste
s:
1. Remove the expansion-card cage and all expansion cards.
2. Place the expansion-card cage on a flat work surface with the riser
board facing up.
3. Remove the two riser-board mounting screws.
4. Slide the riser board over (as shown by the arrow in Figure 5-18) until
it stops; then lift the riser board away from the expansion-card cage.
riser-board mounting screws (2)
To Next Page
Loading...
