Dell OptiPlex Gn - Front-Panel Inserts; Figure 5-5. 5.25-Inch Front-Panel Insert Removal

5-6
Dell OptiPlex Gn and Gn+ Systems Service Manual
F
ront-Panel Inserts
Figure 5-5. 5.25-Inch Front-Panel Insert Removal
To remove a 5.25-inch front-panel insert, follow these steps:
1. Lay the computer cover upside down on a flat work surface, with the
front of the cover facing you.
2. From the front of the cover, use your thumbs to push inward on the
insert until it slides off the two posts.
To replace a front-panel insert, position the front-panel insert, and then press the
ring-tabs over the posts. If necessary, use a
1/4
-inch nutdriver to reposition the
ring-tabs.
ring-tabs (2)
posts (2)
computer cover
(upside down)
5.25-inch front-
panel insert