Dell PowerConnect 6224 - Page 184

184 Configuring System Information
Figure 6-55. Add RADIUS Server
3. Enter an IP address and name for the RADIUS server to add.
4. Click Apply Changes .
The new RADIUS server is added, and the device is updated.
Viewing RADIUS Server Status and Removing a Named Server
1. Open the RADIUS Server Configuration page.
2. Click Show All .
The
RADIUS Named Server Status page displays.
Figure 6-56. RADIUS Server Status
3. To remove a named server, select the check box in the Remove column.
4. Click Apply Changes .
The RADIUS server is removed from the list.
Configuring RADIUS Server Settings Using CLI Commands
For information about the CLI commands that perform this function, see the RADIUS Commands
chapter in the CLI Reference Guide . The following table summarizes the equivalent CLI commands you
use.