192 Configuring System Information
Figure 6-63. Telnet Server
The Telnet Server page contains the following fields:
•
New Telnet Sessions
— Controls the administrative mode for inbound telnet sessions. If you set the
mode to Block, new telnet sessions are not allowed, but existing sessions are not interrupted. The
default value is Allow.
•
Telnet Port Number
— Port number on which telnet session can be initiated. This port will be used for
new inbound Telnet session on the switch. After you modify the telnet server port, new inbound telnet
sessions use the new port and existing telnet sessions are not affected.
Modifying Telnet Server Settings
1.
Open the
Telnet Server Configuration
page.
2.
Configure the relevant fields.
3.
Click
Apply Changes
.
The settings are saved, and the device is updated.
Configuring the Telnet Server Using CLI Commands
For information about the CLI commands that perform this function, see the
Telnet Server Commands
chapter in the
CLI Reference Guide
. The following table summarizes the equivalent CLI commands you
use.
Table 6-36. Telnet Server Commands
CLI Command Description
ip telnet server disable Enables/disables the Telnet service on the switch.
ip telnet port Configures the Telnet service port number on the switch.
show ip telnet Displays the status of the Telnet server and the Telnet service port
number.
To Next Page
Loading...
