Configuring Switching Information 399
•
Leave Timeout
— Specifies time, in seconds, after a port leave message is received before the entry is
aged out. Enter an amount of time for the timeout period, or click
Immediate Leave
to specify an
immediate timeout. The default timeout is 10 seconds.
Enabling IGMP Snooping on an Interface
1.
Open the
General
IGMP
snooping page.
2.
Select the unit and port, LAG, or VLAN to configure from the
Interface
field.
3.
Complete the fields on the page as needed.
4.
Click
Apply Changes
.
IGMP snooping is enabled on the selected interface.
Displaying the IGMP Snooping Table
1.
Open the
IGMP Snooping
page.
2.
Click
Show All
.
The
IGMP Snooping Table
displays.
Figure 7-78. IGMP Snooping Table
3.
Use the
Unit
drop-down menu to view the
IGMP Snooping Table
for other units in the stack, if they
exist.
Modifying IGMP Snooping Settings for Multiple Ports, LAGs, or VLANs
1.
Open the
General
IGMP
snooping page.
2.
Click
Show All
.
The
IGMP Snooping Table
displays.
3.
Click
Edit
for each Port, LAG, or VLAN to modify.
4.
Edit the IGMP Snooping fields as needed.
To Next Page
Loading...
