Dell PowerEdge R740xd - Removing the Expansion Card from Expansion Card Riser

Figure 74. Closing the PCIe card holder latch
Next step
Follow the procedure listed in After working inside your system.
Removing the expansion card from expansion card riser
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 If applicable, remove the air shroud.
4 If applicable, disconnect the cables from the expansion card.
5 When removing a card from riser 2 or 3, ensure that the PCIe card holder latch is closed.
Steps
1 Pull the expansion card latch out of the slot.
2 Hold the expansion card by its edges, and pull the card until the card edge connector disengages from the expansion card connector
on the riser.
Installing and removing system components
129