Dell PowerEdge R740xd - Installing 3.5 Inch Drive into the Drive Carrier

Figure 43. Removing 3.5 inch drive from the drive carrier
Next step
Install 3.5 inch drive into the drive carrier.
Related link
Installing 3.5 inch drive into the drive carrier
Installing 3.5 inch drive into the drive carrier
Prerequisite
Follow the safety guidelines listed in Safety instructions.
CAUTION
: Mixing drives from previous generations of PowerEdge servers is not supported.
Steps
1 Align the tabs on the drive carrier with the slots on the drive.
2 Pull the edges of the carrier to t over the drive.
3 Lower the drive carrier onto the drive to secure it.
94
Installing and removing system components