Dell S4048-ON - Sample Configurations; VRRP for an Ipv4 Configuration

The default is 0.
Sample Congurations
Before you set up VRRP, review the following sample congurations.
VRRP for an IPv4 Conguration
The following conguration shows how to enable IPv4 VRRP. This example does not contain comprehensive directions and is intended to
provide guidance for only a typical VRRP conguration. You can copy and paste from the example to your CLI. To support your own IP
addresses, interfaces, names, and so on, be sure that you make the necessary changes. The VRRP topology was created using the CLI
conguration shown in the following example.
Figure 160. VRRP for IPv4 Topology
1096
Virtual Router Redundancy Protocol (VRRP)