Dell S4048-ON - Configuring Anycast RP

Figure 91. MSDP with Anycast RP
Conguring Anycast RP
To congure anycast RP, use the following commands.
1 In each routing domain that has multiple RPs serving a group, create a Loopback interface on each RP serving the group with the
same IP address.
CONFIGURATION mode
interface loopback
2 Make this address the RP for the group.
CONFIGURATION mode
ip pim rp-address
3 In each routing domain that has multiple RPs serving a group, create another Loopback interface on each RP serving the group with a
unique IP address.
CONFIGURATION mode
interface loopback
572
Multicast Source Discovery Protocol (MSDP)