Dell S4048-ON - Resetting an Interface to Its Factory Default State

To determine which physical interfaces are available, use the show running-config command in EXEC mode. This command displays
all physical interfaces available on the system.
Dell#show running
Current Configuration ...
!
interface TenGigabitEthernet 2/6
no ip address
shutdown
!
interface TenGigabitEthernet 2/7
no ip address
shutdown
!
interface TenGigabitEthernet 2/8
no ip address
shutdown
!
interface TenGigabitEthernet 2/9
no ip address
shutdown
Resetting an Interface to its Factory Default State
You can reset the congurations applied on an interface to its factory default state. To reset the conguration, perform the following steps:
1 View the congurations applied on an interface.
INTERFACE mode
show config
Dell(conf-if-te-1/5)#show config
!
interface TenGigabitEthernet 1/5
no ip address
portmode hybrid
switchport
rate-interval 8
mac learning-limit 10 no-station-move
no shutdown
2 Reset an interface to its factory default state.
CONFIGURATION mode
default interface interface-type]
Dell(conf)#default interface tengigabitethernet 1/5
3 Verify the conguration.
INTERFACE mode
show config
Dell(conf-if-te-1/5)#show config
!
interface TenGigabitEthernet 1/5
no ip address
shutdown
All the applied congurations are removed and the interface is set to the factory default state.
Interfaces
395