EasyManua.ls Logo

Dell S4048-ON - Important Points to Remember; Enabling UDP Helper; Configuring a Broadcast Address

Dell S4048-ON
1146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Important Points to Remember
The existing ip directed broadcast command is rendered meaningless if you enable UDP helper on the same interface.
The broadcast trac rate should not exceed 200 packets per second when you enable UDP helper.
You may specify a maximum of 16 UDP ports.
UDP helper is compatible with IP helper (ip helper-address):
UDP broadcast trac with port number 67 or 68 are unicast to the dynamic host conguration protocol (DHCP) server per the ip
helper-address conguration whether or not the UDP port list contains those ports.
If the UDP port list contains ports 67 or 68, UDP broadcast trac is forwarded on those ports.
Enabling UDP Helper
To enable UDP helper, use the following command.
Enable UPD helper.
ip udp-helper udp-ports
Example of Enabling UDP Helper and Using the UDP Helper show Command
Dell(conf-if-te-1/1)#ip udp-helper udp-port 1000
Dell(conf-if-te-1/1)#show config
!
interface TenGigabitEthernet 1/1
ip address 2.1.1.1/24
ip udp-helper udp-port 1000
no shutdown
To view the interfaces and ports on which you enabled UDP helper, use the show ip udp-helper command from EXEC Privilege
mode.
Dell#show ip udp-helper
--------------------------------------------------
Port UDP port list
--------------------------------------------------
te 1/1 1000
Conguring a Broadcast Address
To congure a broadcast address, use the following command.
Congure a broadcast address on an interface.
ip udp-broadcast-address
Examples of Conguring and Viewing a Broadcast Address
Dell(conf-if-vl-100)#ip udp-broadcast-address 1.1.255.255
Dell(conf-if-vl-100)#show config
!
interface Vlan 100
ip address 1.1.0.1/24
ip udp-broadcast-address 1.1.255.255
untagged TenGigabitEthernet 1/2
no shutdown
To view the congured broadcast address for an interface, use show interfaces command.
Dell#show interfaces vlan 100
Vlan 100 is up, line protocol is down
Address is 00:01:e8:0d:b9:7a, Current address is 00:01:e8:0d:b9:7a
Interface index is 1107787876
446
IPv4 Routing

Table of Contents

Related product manuals