Establishing Sessions with OSPF Neighbors for the Default VRF
BFD sessions can be established with all OSPF neighbors at once or sessions can be established with all neighbors out of a specic
interface. Sessions are only established when the OSPF adjacency is in the Full state.
Figure 13. Establishing Sessions with OSPF Neighbors
To establish BFD with all OSPF neighbors or with OSPF neighbors on a single interface, use the following commands.
• Enable BFD globally.
CONFIGURATION mode
bfd enable
• Establish sessions with all OSPF neighbors.
ROUTER-OSPF mode
bfd all-neighbors
• Establish sessions with OSPF neighbors on a single interface.
Bidirectional Forwarding Detection (BFD)
155
To Next Page
Loading...
