E105, 313327, REV A Protocol 3
TM
User Guide
©2021 ITW EAE. All rights reserved. Despatch is a registered trademark in the U.S. and other
countries. No part of the contents of this manual may be reproduced, copied or transmitted in any form
or by any means without the written permission from ITW EAE, unless for purchaser's personal use.
6.5.1. Working with USB Memory Stick Folders and Files
Insert a memory stick into the port on
the front panel (Figure 24). The
Protocol 3 performs an initialization
process that finds and/or creates
folders on the memory stick (Figure
25):
• DEVICE: This folder must be located
in the Root of the USB memory
stick
• CONFIG: Configuration files (*.bct)
• PROFILE: Profile program files (*.pfl)
• RECORDER: Recorder log folders and
files. The user is asked for a new
recorder subfolder name before
transferring recorder data to USB.
The log files (*.csv) are placed in this
folder.
Files must be located in these folders to be used by the controller.
When preparing to upload files from your PC, ensure that you
save them to the correct folder on the memory stick.
Note: to speed up the disk operation, keep the number of files
stored in these folders to a minimum.
If the file or folder named already exists, data will be
overwritten.
Do not remove the memory stick from the USB port while a data
transfer operation is in progress. Data loss or corruption may
result.
Figure 24. USB Port on Front Panel.
Figure 25. USB Files and Folders Requirements (as
seen from Windows Explorer).
To Next Page
Loading...
Need help?
General
