DS-320SA
Instruction Manual - 10 -
www.doallsaws.com
3.6 PRODUCTION LABEL
Every machine is equipped with an aluminium tag that contains main technical information answering to the
working and constructional specifications. This tag cannot be removed and must be clean and legible. All
data on this tag must be specified in case of order of spare parts or service.
For your information and future reference, pertinent data concerning your machine should be written in the
spaces provided above. This information is printed on a label attached to your machine. Be sure to provide
machine model and serial numbers with any correspondence or parts orders.
Specifications contained herein were in effect at the time this manual was approved for printing. The DoALL
Company, whose policy is one of continuous improvement, reserves the right, however, to change
specifications or design at any time without notice and without incurring obligations.
PLEASE READ THIS MANUAL CAREFULY BEFORE OPERATING THE MACHINE!
For Sales, Parts and Service, call 1-888-362-5572
For general information, visit our web site at: www.doallsawing.com
To Next Page
Loading...
