DS-320SA
Instruction Manual - 61 -
www.doallsaws.com
13. MAINTENANCE
DAILY:
Remove the chips from the storage tank.
Add coolant or cut liquid, check right proportion of diluting.
Inspect the band for wear; replace the band, if necessary.
WEEKLY:
If the hydraulic or gear oil does not extrudes, see the regulations for changing the fillings. In
other case order DoALL service.
To clean and oil all movable parts and leading surfaces.
Check the control panel functions.
Pay attention for cleanness of terminal switches.
Microswitches - check
It is essential to replace the hydraulic hoses every eight years.
tab: 13-1
To Next Page
Loading...
