DS-320SA
Instruction Manual - 57 -
www.doallsaws.com
12.9 ROLLER TABLE
To properly connect roller tables to machine DS-320SA is necessary:
1) Before the cutting zone, on input you have to equip machine with LR-RDP. On output you have to use
roller table LR-RDZ. To connect directly the table to machine, there is connecting part used – 290 LR-PR –
which is included as the part of this type of roller table. In case you would connect roller table RD directly to
the machine, the angle cutting would be disabled, connecting part 290 LR-PR is not a part of this type of
roller table.
pic: 12-2
Screws for machine: Hexagon socket screw M10x35 by DIN 912 01 M10X35 (2x), pad size 12 (2x)
Installation screws for roller table connection: hex head screw M10x60 (2x), pad size 11 by DIN 126 01 10
(4x), nut M10 (6x).
pic: 12-3
1. Input roller table 290 LR-RDP
2. Output roller table 290 LR-RDZ
3. Operating panel
To Next Page
Loading...
