DoAll DS-320SA - 14.7 HOW TO SOLVE PROBLEMS-MACHINE

DS-320SA
Instruction Manual - 72 -
www.doallsaws.com
14.7 HOW TO SOLVE PROBLEMS-MACHINE
problem solution
blade motor does not work 3,4,5,9
motor of hydraulic circuit does not work 1,2,3,4,5,9,17
el.panel does not shine 6,7,8,9,
cooling is insufficient 18,19,20,21,24
cut piece is moving or is deformed 22,23
1
plug is not in the socket
2
main switch is out
3 the engine is burned or damaged
4
el.source is not correct
5 gearbox is blocked – nylon clutch, wheels of the gear box, shaft seating
6
fuses in a primary circuit
7 fuses in a control panel
8
transformer is damaged or burned
9 .connection of the suplying cable
18
damaged hydraulic valves
19 filters for coolant must be cleaned or changed
20
coolant pump does not work
21 the tank is empty or dirty
22
excessive movement of the arm towards the cut
23 the vice is not clamped properly, the material is not clamped well
24
by pressing button Lubricant off the coolant pump is off
tab: 14-2