DS-320SA
Instruction Manual - 35 -
www.doallsaws.com
9.6 INITIATION OF THE MACHINE INTO THE STAND-BY MODE
pic: 9-2
1. The saw must be connected to the mains.
2. Turn on the main switch to position 1 (pos.5).
3. If the saw was turned off with EMERGENCY STOP button (pos. 4) unlock the EMERGENCY STOP
button by turning it to the right. With this, the machine is prepared for cutting.
4. Set the feed rate (pos. 1) to minimum
5. In case of MINI-LUBE (not standard equipment) choose the mode of emulsion input.
6. The turntable must be well arrested before cutting.
To Next Page
Loading...
