Coding System
DODGE
Turbo Diesel
Coding System Replacement Procedures
Page 7-17
1 3/8 Inch Push Pin
Support the bearing housing
with
a bearing splitter between
the bearing and the fan mounting hub.
Push
the shaft out
with
a
1
3/8 inch diameter push pin.
Note:
Approximately 6 tons of
pressure
Is required.
2 Inch Black Pipe - 2 3/8 Inch O.D. X 4 Inch long
Support the bearing housing and push the bearing out using a
tool
of suitable diameter to press on the outer race of the
bearing. A 4-inch section of black pipe
with
2 3/8 inch O.D.
will
work well.
Make
sure the ends of the pipe section are exactly
perpendicular to the length.
Push
it
flush
with
the
front
of the housing.
To Next Page