Electrical
System
DODGE
Turbo Diesel
Engine
Electrical
System Replacement Procedures
Page8-15
Oil Pressure Switch/Sending Unit Socket
Replace
the switch and connect the electrical connector.
Tighten the oil pressure switch.
Torque Value: 16 N-m [12 ft-lbs]
Temperature Sensor - Replacement
Warning:
Walt
until
the temperature Is below 50°C
[120°F] before removing the coolant system pressure
cap.
Failure to do so can cause personal injury
from
heated coolant spray.
Drain the coolant system by opening the drain valve on the
radiator. A drain pan
with
a capacity of 20 liters [5 U.S. gallons]
will
be adequate to hold the coolant.
Disconnect
the temperature sensor wiring. Clean the area
around the
sensor
thoroughly.
1 1/16
inch
Socket
Remove the temperature
sensor.
To Next Page