Dodge D250 1990 - Vehicle Identification Number; Vehicle Identification Plate; Vehicle Safety Certification Labels

Introduction
Page 14
O
Dodge
Fargo
"Plymouth
DcSOTD
O
MARCAS REG TMS REG U.S. PAT. OFF.
MODEL.
MAX GVW
GROSS VEHICLE WEIGHT (QVW) IS TOTAL WEIGHT OF WCOBPOFU
THE VEHICLE INCLUDING OPTIONS, DRIVER, PASSENGERS,
BODY & PAYLOAD. "SEE OPERATORS MANUAL PACKAGE FOR
SPECIFIC EQUIPMENT REQUIRED FOR A GIVEN GVW RATING.
WARRANTY VOID IF ANY RATINGS ARE EXCEEDED FOR THE
_ ACTUAL GVW & GAWR RATINGS OF THIS VEHICLE. SEE THE
Q SAFETY CERTIFICATION LABEL MADE IN U.S.A.
o
CHRYSLER
W CORPORATION
MODELS
EQUIPMENT IDENTIFICATION
V.I.N.
CHRYSLER MOTORS
DODGE Turbo Diesel
VEHICLE AND COMPONENT IDENTIFICATION
Vehicle Identification Number: For 1990, (V.I.N.) will consist
of 17 elements (numbers and letters) embossed on a plate,
located on the upper left corner of the instrument panel, near
the windshield. Refer to 1990 "V.I.N. Code Chart", for
Alpha/Digit positions and V.I.N, interpretations.
The Vehicle Identification Number is located on the Vehicle
Identification Plate, Equipment Identification Plate and on the
applicable U. S. Federal Motor Vehicle Safety Standards
"Certification Label" and Frame Rail.
Vehicle Identification Plate The vehicle identification plate as
shown is attached to the rear face of the driver's door, or on
the post, on ail models.
Equipment Identification Plate
The equipment identification plate as shown contains
information regarding the vehicle: model, wheel base, V.I.N.
(Vehicle Identification Number), T.O.N.(Order Number), and all
production or special equipment on the vehicle when it was
shipped from the factory. Always refer to this plate when
ordering parts. The location of the equipment Identification
Plate is as follows:
Model Location
Conventional Cab Hood Inner Surface
jDATE OF MFGRjjeVWR
GAWR FRONT II WITH TIRES
RIMS' AT ' " l^i'cbEE
GAWR REArl | WITH TIRES
RIMS AT JJPS1 CODE
SlNGi^flUALjTl
VEHICLE NUMBER
I VEHICLE TYPE
Vehicle Safety Certification Labels
A vehicle safety certification label is attached to the rear facing
of the driver's door on all models. This label reflects the date of
manufacture numerically month and year, Gross Vehicle
Weight Rating (GVWR), Gross Axle Weight Rating (GAWR)
front, Gross Axle Weight Rating (GAWR) rear and Vehicle
Identification Number (VIN). A Month-Day-Hour (MDH) number
is included on this label and indicates the Month, Day and Hour
of manufacture.
This label when applied, verifies vehicle conformation to alt
applicable Federal Motor Vehicle Safety Standards in effect on
the date of manufacture.
All communications or inquiries regarding the vehicle should
include the Month-Day-Hour and Vehicle Identification Number.
\