Dodge D250 1990 - Tappet - Removal

In-Chassis Repairs
Page9F-40
Base Engine Components
DODGE Turbo Diesel
Install the bushing so that it is even with the front face of the
cylinder block, using a universal cam bushing installation tool.
Caution; The oil hole must be aligned.
2h A 3.2mm [0.128 inch] diameter rod must be able to
through the hole.
Measure the installed bushing.
Limits
Inside Diameter: 54.133mm [2.1312 inch]
Tappet - Removal
Tappet Removal Service Tool
Insert the trough to the full length of the cam bore.