Dodge D250 1990 - Base Engine Components Out-Of-Chassis Repairs; DODGE Turbo Diesei; Piston and Rod Assembly - Removal

Base Engine Components
DODGE Turbo Diesei
Out-of-Chassis Repairs
Page 91-3
Piston and Rod Assembly - Removal
Caution: Make sure the ridge reamer does not make a
deep cut Into the bore. Do not remove more metal than • V
Is necessary to remove the ridge.
If the cylinder bores have ridges, use a ridge reamer to cut the
ridge from the top of the cylinder bore before removing the
piston.
Note: If cylinders have ridges, the cylinders are oversize and
will need reboring.
Hammer, Steel Number Stamps
Mark the cylinder number onto each connecting rod cap.