Operating instructions
Page
OB-6
Lubrication
ami Maintenance
DODGE
Turbo Diesel
BRAKE
(£><
CUMMINS
TURBO DIESEL.
LOW
FUEL
DIESEL FUEL
ONLY
WATER
IN
FUEL
WAIT TO
START
ANTI-LOCK
Message
Center Lights
The
engine warning light panel on the dash contains five
warning indicator lights: Brake, Water in
Fuel,
Wait
to Start,
Anti-Lock,
and Low
Fuel.
BRAKE
<B <D
CUMMINS
TURBO DIESEL
LOW
FUEL
DIESEL FUEL
ONLY
WATER
IN
FUEL
WAIT TO
START
ANTI-LOCK
A
Brake
Light
-
Diesel Powered Trucks
The
Brake light is
connected
to a
sensor
that monitors vacuum
in the brake booster
system.
The Brake light when lit indicates
LOW
VACUUM. If this light is lit, the brake system must be
serviced*.
* Note: This maintenance procedure must be performed by a
trained
service
technician.
Note: The brake light will be activated when the Park Brake is
applied or in the event of a hydraulic brake failure.
BRAKE
<B
<
CUMMINS
TURBO DIESEL
LOW
FUEL
DIESEL FUEL
ONLY
WATER
IN
FUEL
WAIT TO
START
ANTI-LOCK
A
Water in Fuel
The
Water In Fuel light is
connected
to a
sensor
located in the
fuel
filter.
If water
collects
in the fuei\water separator
filter,
the
Water In Fuel indicator will light. Refer to page
OC-5
to drain
the water from the fuel\water separator
filter.
BRAKE
(BCD
CUMMINS
TURBO DIESEL
WATER
IN
FUEL
LOW
FUEL
DIESEL FUEL
ONLY
WAIT TO
START
ANTI-LOCK
A
Walt
to Start
The
Walt
to Start light is
connected
to a
sensor
that monitors
the intake manifold temperature in the cylinder head. When the
intake manifold temperature is below -9°C [15°F] (early module
before serial number 0080000A) or 15°C [59°F] (late module)
and the ignition switch is in the ON position, the control module
sends
power to the intake manifold air heaters and the
Walt
to
Start light.
When starting the engine, if the
Walt
to Start light
comes
on,
leave
the key in the "ON" position until the light goes out, then
start the engine.
To Next Page
Loading...
