Dodge D250 1990 - Air Cleaner Element Replacement; Intake Manifold Heater - Replacement; Remove

Exhaust System and Intake Manifold
DODGE Turbo Diesel
Air System
Page 11-19
5/16 inch, 10mm
9
15mm, 5/8 inch
Install the turbocharger, air crossover, oil drain tube, oil supply
line, and the exhaust and intake piping.
Torque Values:
• Turbocharger air crossover clamp - 5 N-m [44 in-lbs]
• Drain line capscrews - 24 N-m [18 ft-lbs]
• Turbocharger mounting nuts - 32 N-m [24 ft-lbs]
• Turbocharger oil supply line -15 N-m [11 ft-lbs]
• Cab heater supply and return lines -24 N-m [18 ft-lbs]
Operate the engine to check for leaks.
Intake Manifold Heater - Replacement
Remove
10mm, 13mm
Disconnect the throttle rod from the throttle lever. Remove the
four mounting capscrews (A). Loosen the throttle control
bracket lower mounting capscrew (B) and move the top end
away from the engine.