Dodge D250 1990 - Fuel System Specifications

Fuel System
DODGE Turbo Diesel
Specifications
Page 14-41
Specifications
Torque Values
12 N-m
[9 ft-lbs]
24 N-m
[18 ft-lbs]
8 N-m
[6 ft-lbs]
24 N-m
[18 ft-lbs]
24 N-m
[18 ft-lbs]
24 N-m
[18ft-Ibs]
24 N-m
[18 ft-lbs]
30 N-m
[22 ft-lbs]
13 N-m
[10 ft-lbs]
65 N-m
[48 ft-lbs]
43 N-m
[32 ft-lbs]
24 N-m
[18 ft-lbs]
10 N-m
[7.5 ft-lbs]
.. 32 N-m
[24 ft-lbs]
8 N-m
[6 ft-lbs]
., 60 N-m
[44 ft-lbs]
24 N-m
[18 ft-lbs]
9 N-m
[7 ft-lbs]
24 N-m
[18 ft-lbs]
10 N-m
[7.5 ft-lbs]
.. 2 Amps
Electrical Values - Shut Off Valve:
Current Draw
Minimum Voltage 10 Volts D.C.
Operating Voltage 12 Volts D.C.
Resistance 7.4 Ohms
Engine Speed:
Full Throttle Stop Speed (NO Load) 2,925 RPM Max.
Full Throttle Stop Speed (NO Load) 2,825 RPM Min.
Low Idle Stop Speed (Air Conditioning ON) (Automatic) 700 RPM
Low Idle Stop Speed (Air Conditioning ON) (Manual) 750 RPM
Pressure / Restrictions / Flows
Fuel Pressure Drop Across Fitter 21 kPa [3 psi] Max.
Fuel Return Une Restriction 518 MM Hg [20.4 in Hg] Max.
Injector Operating Pressure (Pop Pressure) 245 bar [3550 psi]
Lift Pump Inlet Restriction 95 MM Hg [3.75 in Hg] Max.
Uft Pump Output - Flow 0.75 liter [0.70 U.S. quart] / 30 Sec. Max.
Lift Pump Output - Pressure 21 to 35 kPa[3to5psi]