CHRYSLER
MOTORS
DODGE
Turbo Diesel
introduction
Page
15
Engine
Serial Number
Parts
Replacement Information On 5.9 Liter
diesei
engines,
the engine serial number is located on the
left
front
corner of
the engine. The engine
serial
number is stamped into the data
plate located on the gear
housing.
S*r.'e»mpmy,
(«e.
Bljtoi I
C.I.OJ
L.-
Sefits CM.
CM.
I.D
J
Jfjf B 0804
B
*
MS,rt-
*' 44252750
S*r.'e»mpmy,
(«e.
Bljtoi I
C.I.OJ
L.-
Sefits CM.
CM.
I.D
J
Jfjf B 0804
"i"""
3909522
S*r.'e»mpmy,
(«e.
iMerme
TOCi^Omm
•*•••«.
41671
W^,^aM
01Q
|N-
W
in
Brt
"^HP
160
w
2500
n*.,!**,
153624
Fu«i
rat.
«t m«fHP
7JJ Q mm'dlroke
SSXttlL.
07/14/89
"°*'"
M
"
6BT -6.9
Transmission
Identification
Operation requirements are, in some
instances,
different for
each
vehicle and engine combination and some internal parts
will be different. Therefore, when replacing parts, refer to the
number stamped on
left
side of the
transmission
oil pan flange.
See
Group 21 of this manual for additionai information. For
manual transmission models, an identification number is
permanently stamped into the right side of the
transmission
case
or a metal tag located on the upper right side of the
transmission.
Fastener
Classification
Metric Thread and Grade Identification Metric and inch
thread notations
differ
slightly.
Common metric fastener strength property
classes
are 8.8 and
12.9
with
the
class
identification
embossed
on the head of each
bolt. Inch strength
classes
range
from
grade 5 to 8
with
line
identification
embossed
on each bolt head
as
shown.
Markings
correspond
to two lines
less
than the actual grade (i.e. grade 8
bolt will exhibit 6 embossed lines on the bolt head). Some
metric nuts will be marked
with
single
digit
strength
identification numbers on the nut face.
[Inch] Bolts—Identification marks
correspond
to bolt
strength—increasing
numbers
represent
increasing
strength.
Metric Bolts—Identification
class
numbers
cor-
respond
to bolt
strength—increasing
numbers
represent
increasing
strength.
To Next Page
Loading...
