Dodge D250 1990 - Specifications

Electrical System
DODGE Turbo Diesel
Specifications
Page 8-25
Specifications
Electrical Capacity
Battery Connection - Nut Size 3/8x16 inch
Maximum Allowable Resistance of Storting Circuit .0012 Ohms
Minimum Recommended Battery Capacity 1025CCA
Starter Switch Connection - Nut Size 8-32 inch
Starting Motor - Nippondenso 12 VDC 3 Kw
Pressures:
Minimum Oil Pressure - idle . 69 kPa [10 psi]
Minimum Oil Pressure - Rated Speed 207 kPa [30 psi]
Torque Values:
Alternator Lower Mounting Capscrew 43 N-m [32 ft-lbs]
Alternator Pulley Retainer Nut 80 N-m [60 ft-lbs]
Alternator Upper Mounting Capscrew 24 N-m [18 ft-lbs]
Cylinder Block heater 12 N-m [9 ft-lbs]
Fuel Heater Adapter 32 N-m [24 ft-lbs]
Fuel Pump Solenoid Valve 43 N-m [32 ft-lbs]
Intake Air Cross Over Tube - Hose Clamps 5 N-m [44 in-lbs]
Intake Air Cross Over Tube - Mounting Capscrews 24 N-m [18 ft-lbs]
Oil Pressure Switch 16 N-m [12 ft-lbs]
Starter Mounting Capscrews 43 N-m [32 ft-lbs]
Starter Positive Cable Nut 22 N-m [16 in-lbs]
Starter Solenoid Nut 5 N-m [44 in-lbs]
Thermistor 24 N-m [18 ft-lbs]
Throttle Control Bracket 24 N-m [18ft-lbs]