Base
Engine
Components
DODGE
Turbo Diesel
In-Chassis
Repairs
Page
9F-33
Use
the alignment/installation tool from the
seal
kit to align the
cover
to the crankshaft.
10mm
Tighten the gear cover
capscrews.
Torque
Value:
24 N.m [18 ft-lbs]
Remove
the alignment/installation tool.
Caution;
Always
use
a
seal
pilot when you install a
seal.
Apply a bead of Loctite 277 to the outside diameter of the
seal.
(0®t
Install the pilot from the
seal
kit onto the crankshaft.. Install the
seal
onto the pilot and start into the front cover. Remove the
pilot.
Alignment/Installation Tool,
Plastic
Hammer
Note: To prevent damage to the
seal
carrier, hit the wMjt
alignment/installation tool alternately at the 12, 3, 6 and 9
o'clock
positions.
Use
the alignment/installation tool and a plastic hammer to
install
the
seal
to the correct depth.
To Next Page
Loading...
