In-Chassis
Repairs
Page9F-46
Base
Engine Components
DODGE Turbo Diesel
Caution:
When
installing the camshaft, do not push it in
farther
than
it
will
go
with
the thrust washer in place. Pushing it too
far can dislodge the
plug
in the rear of the cam
bore
and
cause
an oil leak.
Install the camshaft/thrust washer. Align the
timing
marks as
iliustrated.
13mm
H» Install the thrust washer capscrews and
tighten
to 24 N-m
no
ft
ilid
[18ft-Ibs]
2h
Verify
the camshaft has the correct
amount
of back lash and
*S
end clearance.
A = 0.152 to
0.254mm
[0.006
to 0.010 inch]
B
= 0.08 to
0.33mm
[0.003
to 0.013 inch]
Install the
following
parts.
^c**Refer to
appropriate
sections of this manual for
torque
sequence and values and for clearance specifications.
• Gear cover
-
Vibration
damper
• Rocker levers and valve cover
• Lift
pump
To Next Page