Fuel
System
DODGE
Turbo Diesel
Fuel
System Replacement Procedures
Page 14-29
Bar
the engine
until
the key way on the fuel pump shaft is in the
approximate position shown.
Caution: Be sure to disengage the pin
after
locating TDC.
Locate
TDC for Cylinder Number
1
by barring engine slowly
while pushing in on TDC pin. Stop barring the engine as soon
as
pin engages
with
the gear
timing
hole.
Note;
Check the
timing
marks on the flange of the injection f^Tj
pump.
Each
pump and engine have unique marks. It is not vl/
possible
to exchange pumps and use the same marks for
alignment.
10mm Hex
Loosen
the lockscrew and remove the special washer
from
injection pump. Tighten the lockscrew against the drive shaft.
Tighten the lockscrew.
Torque Value: 30 N-m [22 ft-lbs]
Note:
Wire
the special washer to the pump so it can be re-
installed later.
75mm
T-Bar
Pull the pump drive gear
from
the drive shaft.
Note:
Puller
capscrew
size
is
M8-1.25.
To Next Page
Loading...
