HEALTH AND SAFETY
1-6 EPT024619 Issue 1 June 2016
G-SERIES SYMBOLS
The following symbols are used in this manual. Where they appear next to a
procedure or instruction, they have the significance and importance of
written warnings and cautions.
Eye protection must be worn.
Protective clothing must be worn. Use adequate protective gloves. Consult
the relevant Safety Data Sheet (SDS).
The equipment must be switched off and power removed.
Only trained personnel should carry out this procedure.
Beware of Electrostatic Discharge (ESD). Electrostatic precautions must be
used.
• Switch off machine first
• Wear a wristband connected to the ESD connector provided
• Avoid wearing clothing which can build up electrostatic voltages
• Use ESD protective bags to transport PCBs
• Only place PCBs on a mat made from a material which will dissipate
electrostatic voltages and which is connected to ground.
To Next Page
Loading...
Need help?
General
