INSTALLATION
6-30 EPT024619 Issue 1 June 2016
INTERNAL PRODUCT SENSOR
The G20i is equipped with an internal product sensor to trigger message
printing.
The internal product sensor will generate a print trigger signal when the
leading edge of a product passes the product sensor.
To use the internal product sensor, the product sensor type (page 6-42),
print delay (page 6-44) and print mode (page 6-46) must be set.
To calibrate the internal product sensor, see “Internal Product Sensor
Calibration” on page 6-31.
Internal Product Sensor Location
To Next Page
Loading...
