INSTALLATION
6-44 EPT024619 Issue 1 June 2016
Set the Print Delay
The procedures below, describe how to set the print delay values.
The print delay values, set the distance between when a print trigger signal
is received by the G20i and the point when a message is printed.
The print delay values also set the distance between printed messages.
Using the Wireless USB Keyboard
To set the print delay using the wireless USB keyboard:
(1) From the main menu, highlight Settings.
(2) Press the Enter button.
(3) Move the cursor to highlight Delay.
(4) Press the Enter button.
(5) Change the Delay Before value to set the distance between when the
print trigger is activated, and the point when the message will print.
(5mm to 500mm)
(6) Change the Delay After value to set the distance between when the
message has finished printing, and when the next message will start
printing. (50mm to 500mm)
(7) Press the Enter button.
Using a PC
To set the print delay using a PC:
(1) Open the Domino G20i software.
(2) Open the Printer Control menu.
(3) Under the Sensor tab, change the Delay Before value to set the
distance between when the print trigger is activated, and the point
when the message will print. (5mm to 500mm)
(4) Under the Sensor tab, change the Delay After value to set the
distance between when the message has finished printing, and when
the next message will start printing. (50mm to 500mm)
To Next Page
Loading...
Need help?
General
