Domino G20I - Mounting the G20 I to a Conveyor

INSTALLATION
6-8 EPT024619 Issue 1 June 2016
Mounting the G20i to a Conveyor
Tools Required:
•3mm hex key
•6mm hex key
To mount the G20i to a conveyor:
(1) Mount the Anti Shock Clamp to the side of the G20i.
(2) Mount the Base Clamp and 19 x 200mm Round Bar to the side of the
conveyor.
G20i Printer
Anti Shock Clamp
19 x 200mm
Round Bar
Base Clamp