INSTALLATION
EPT024619 Issue 1 June 2016 6-47
Continue Mode
To set the print mode as Continue, using the wireless USB keyboard:
(1) From the main menu, highlight Settings.
(2) Press the Enter button.
(3) Move the cursor to highlight Print Mode.
(4) Press the Enter button.
(5) The following settings can now be configured.
(6) Press the Enter button.
Mode: Select Continue.
Delay: Enter the distance between each printed
message. (10 - 10,000)
Enable: Select either:
Level - A sensor signal will be required to start
printing.
Immediate - The G20i will start printing
immediately after Start is selected from the
Message menu.
To Next Page
Loading...
