Doosan DISD SD 310 - Page 332

Loosen hex. lead screws (Figure 76) and pull pin by
means of Special device out of the housing bore
(Figure 77).
( S ) Puller device 5870 000 066
Tilt gear case 180°.
Pry shaft seal out of the housing bore.
Squeeze out circlip and remove spacing washer.
( S ) Circlip pliers 5870 900 021
SPC000007 Transmission and Torque Converter
Page 104
Figure 76
Figure 77
Figure 78
Figure 79