3.2.3.4 Install plate pack K3
Install plate pack and check clearance.
NOTE ;
Plate arrangement, see plate installation,
Page 119 ... 122 !
3.2.3.5 Pre-assemble and install spur gear K3
1 = Thrust plate
2 = Thrust washer
3 = Needle cage
4 = Spur gear
5 = Cylindrical rollers
NOTE :
Exchange cylindrical rollers 5 in sets only !
Install components 2 ... 5, replace thrust plate 1
(Arrow) and introduce spur gear until all inner plates
arc received.
NOTE ;
Make thrust washer 2 and cylindrical rollers 5
adhere with grease.
3.2.3.6 Install clutch K4/K3
Adjust end play of clutch 0,1 ... 0,3 mm (Figure148
to Example ―E‖)
Determine Dimension I from the flange-mounted
surface/axle to the plane surface/housing (Arrow).
Dimensione.g. 251,15 mm
NOTE :
In case of spur gear bearing K4, Version "B" (Figure
144), lay forked washer and thrust washer upon the
plane surface of the housing and measure up to the
thrust washer.
Transmission and Torque Converter SPC000007
Page 125
To Next Page
Loading...
