Squeeze in and engage rectangular rings (1).
Install O-Ring (2).
NOTE ;
Crease and align rectangular rings centrically.
Install stud bolts, see Arrows !
NOTE :
Secure the stud bolts with Loctite (Type-No. 270) !
Heat housing bores (about 90° C).
( S ) Hot-air blower 220 V 5870 221 503
( S ) Hot-air blower 110 V 5870 221 501
Thread up axle (compl.) until contact is obtained.
SPC000007 Transmission and Torque Converter
Page 128
To Next Page
Loading...
